Klogic Configuration
The Configuration Dialog of Klogic can be accessed via the "Global Settings" of the Options menu. Here you can
predefine the most common settings of klogic. Mainly there are Options for the default settings of new devices,
wich you can define for each device individually via its "Properties" dialog, so i don't explain them here further.
The most important settings are the settings within the box called "simulation". Here you can set the simualtion speed,
and the burst value. When changing the speed value, you can change the time between each Simulation step. The burst
value affects the Delay settings of each device. You may also have a look at the Simulation Section
of this Document.
You can also change the font, klogic uses to display devicenames etc. at the drawboard. I recommend to leave this
setting as it is.
at the right-lower side you can select wich fileformat klogic should use when saving documents. Since i had problems
with the old format, I'm using the XML format.
The last Option is the symbolset. You can choose between European-normed symbols (DIN 40900) and IEC617 normed
symbols.
Prev.(Getting Started)
